-
Description
This self-test cable works with the Sequent Home Automation 8-layer stackable HAT, allowing you to test groups of three inputs and outputs on the HAT.
Features
- Three-connector cable for self-testing the Sequent Home Automation HAT
- Self-test groups of 3 inputs and outputs
- Command-line software for each test
How to Use
Test the GPIO and Opto-Inputs 1-4:
Insert the cable on the left side of the card, as shown in the picture below, and run the self-test command
Test the analog inputs and outputs:
Insert the cable on the bottom side of the card, as shown in the following picture, and run the self-test command.
Test the open-drain outputs and opto-inputs 5-8:
Insert the cable on the right side of the card, as shown in the following picture, and run the self-test command.
Testing the relays
Without the loopback cable, run the command relay_test. Relays will cycle on and off in sequence and the corresponding LED's will turn on and off.
